Lincoln 2010 Navigator Bedienungsanleitung PDF herunterladen (Seite 271)

BRAKE-SHIFT INTERLOCK – FLOOR-SHIFT TRANSMISSION

This vehicle is equipped with a brake-shift interlock feature that prevents

the gearshift lever from being moved from P (Park) when the ignition is

in the on position unless the brake pedal is pressed.

If you cannot move the gearshift lever out of P (Park) with ignition in

the on position and the brake pedal pressed, it is possible that a fuse has

blown or the vehicle’s brakelamps are not operating properly. Refer to

Fuses and relays in the Roadside Emergencies chapter.

If the fuse is not blown and the brakelamps are working properly, the

following procedure will allow you to move the gearshift lever from P

(Park):

1. Apply the parking brake, turn the

ignition key to the off position, and

remove the key.

2. Using a screwdriver (or similar

tool), carefully pry off and remove

the chrome trim ring (1) from the

shifter bezel base.

3. Using a screwdriver (or similar

tool), carefully pry the trim panel

(2) up and disconnect it from the

console to expose the inside of the gearshift.

4. Locate the brake shift interlock

lever on the passenger side of the

shifter assembly.

5. Apply the brake pedal. Using a

screwdriver (or similar tool), press

and hold the brake shift interlock

lever while pulling the gearshift

lever out of the P (Park) position

and into the N (Neutral) position.

6. Install the trim panel (2) and

chrome ring (1) in reverse order.

7. Apply brake pedal, start the vehicle, and release the parking brake.

See your authorized dealer as soon as possible if this procedure

is used.

Driving

271

2010 Navigator (nav)

Owners Guide (own2002), 1st Printing

USA (fus)

1 2 ... 266 267 268 269 270 271 272 273 274 275 276 ... 384 385

Keine Kommentare

Lincoln 2010 Navigator Bedienungsanleitung Seite 271